蒸汽管道保溫 鍍鋅鐵皮鋁皮設備施工全程介紹

管道保溫先鋪設保溫管殼本工程蒸汽管道保溫采用硅酸鋁纖維制品，然后用鍍鋅鐵絲將管殼綁扎牢固，每層材料都用鍍鋅鐵絲綁扎，每塊保溫材料不少于兩道雙股鐵絲，保溫材料鋪設時要錯縫壓縫。主保溫層鋪設結束后進行外護層的施工，外護層采用金屬外護，本工程采用厚度為0.5mm的鋁合金板。金屬外護下料 由于本工程保溫設備直徑較大應增加鋼帶捆扎保溫棉來滿足保溫效果。 2.2對于不能焊接保溫鉤釘的設備保溫施工時應采用鐵絲加鋼帶捆扎法即將保溫材料鋪設在設備上后先用鐵絲捆扎再用鋼帶捆扎固定。安裝保溫板材時先用繩將保溫板材作預固定然后用鐵絲、鋼帶固定每隔200mm扎一道鐵絲每隔500mm設一道鋼帶。 2.3封頭保溫封頭保溫時應先制作活動環保溫板材鋪設時應將保溫材料按封頭尺寸加工成扇形塊然后用鍍鋅鐵絲一端系在活動環上另一端系在切點位置的固定環上捆扎成輻射型扎緊必要時可在扎緊條間扎一環狀拉條環狀拉條扎緊條成十字扭結扎緊當封頭保溫為雙層結構時應分層捆扎。 2.4所有銘牌不得遮蓋應將銘牌周圍的保溫層切割成喇叭形開口開口處應密封規整。 3、鍍鋅鐵皮保護層制作安裝。 3.1直管施工。 3.1.1確定下料長度用鋼皮尺或鐵皮條在保溫管道外面多量幾個部位按保溫層外圓周長加長45mm搭接尺寸插接和咬接確定下料值。 3.1.2加工接縫在手動板邊機上做好靠點大頭12mm小頭15mm并將大頭端做好記號。?
管道保溫是由四部分組成的，首先我們來看一下工作鋼管，它的主要作用是輸送。這些鋼管可以選擇無縫的鋼管，也可以選擇有縫的鋼管。保溫層也是它的一個組成部分，它主要是一種塑料制品，就是硬質的聚氨酯泡沫。保護殼也是管道保溫的一部分，這部分主要是用的聚乙烯，同時這類聚乙烯必須是高密度的才可以